(800) 853-2651
SHOP NOW

Tractor wheel/dish question

R

RGMartin

Well-known Member
I am building a project. I need to find a set of 38" rear dishes/wheels that have the small 8 bolt on 6" pattern.

Did anyone even use the small 8 bolt pattern on a 38" wheel, Need to be adjustable in one way or another too. Either Power adjust, or by flipping wheels and dishes around.


Where should I begin looking, or am I going to be making a set?
 
AC and MF used a 38" rims with that 8 bolt patern. I have a set on a D17 Hi-Clearance tractor and had a MF 65 that had the same rims on it as the AC. I have seen tham with 13.6 14.9 and 15.5x38s on them. There out there you just have to look in the bone yards to find a set. Bandit
a88052.jpg

a88053.jpg
 
The ACs and MFs I have seen and played with have the 8 on 8" with the 6 inch center hole.

I am looking for the smaller pattern like a TO30, or 3 cylinder DB would have. Like a 4.25" center hole
 
The Ferguson 40 and MH50 or MF50 Hi-Clearance all had 38 inch
rims on the centre you need. It was available in power adjust or
fixed centre.
Sam
a88056.jpg
 
Fellow up the road from the farm has a 4000 Ford with 13.6x38 tires with the small 8 bolt patern you are talking about. There was a set that was for sale on Photo adds not to long ago off a Ford. May be worth going back through them and see if there still there. Bandit
 
You must log in or register to reply here.

Similar threads

B
single front wheel Farmall questions
Replies
7
Views
441
DeltaRed
D
R
Big blue wheel hub
Replies
2
Views
507
used red MN
U
A
Help with moving wheels to 40 row spacing on massey 35 d
Replies
3
Views
377
Bob N.Y.
Bob N.Y.
W
rear wheel seals leaking
Replies
6
Views
674
winter411
W
M
Farmall Steering Wheel Removal
Replies
3
Views
315
SinkholeRoad
S
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top