Got a new hyd pump front mount for my mf 205 industrial, where both hoses came in from the left, if standing in front of the tractor looking at it.
The inlet is on the left side of pump and my 1.25" bulk hose will reach that just fine.
The outlet is SAE 12 F and is on the right side of the pump...I don't think I have enough hose to do a 180 degree turn so I was thinking about doing 2 elbows off the pump so the hose can reach.
The fitting from the outlet off the old pump is an elbow SAE 10 M which went in the old pump to -10 JIC M which hose attached to...and this fitting went on the top of the old pump.
So, how do I do the 2 elbows? Would there be a swivel involved somewhere so I could line things up when tight? I just can't wrap my mind around this...maybe someone could help me...thanks.
The inlet is on the left side of pump and my 1.25" bulk hose will reach that just fine.
The outlet is SAE 12 F and is on the right side of the pump...I don't think I have enough hose to do a 180 degree turn so I was thinking about doing 2 elbows off the pump so the hose can reach.
The fitting from the outlet off the old pump is an elbow SAE 10 M which went in the old pump to -10 JIC M which hose attached to...and this fitting went on the top of the old pump.
So, how do I do the 2 elbows? Would there be a swivel involved somewhere so I could line things up when tight? I just can't wrap my mind around this...maybe someone could help me...thanks.
