ObsoElitist
Member
I hav a mid-70s Miller 12000 Lbs tilt deck trailer and broke both springs hauling a 9500 Lbs Bobcat on bad mountain roads today. Both showed rust in the crack at least 3/4 of the way through, so it wasnt someting I did today, it was just time.
It is an unusual setup, a walking beam spring like this, only the axles are below the spring.
There is a spring shop 90 miles away who can make new springs, but I should take the pivots apart and see about rebuilding them too.
Does anyone know of a source for parts, or if the pivots are made of common parts for something else?
It is an unusual setup, a walking beam spring like this, only the axles are below the spring.
There is a spring shop 90 miles away who can make new springs, but I should take the pivots apart and see about rebuilding them too.
Does anyone know of a source for parts, or if the pivots are made of common parts for something else?