(800) 853-2651
SHOP NOW

New Brackets for CNC Mill

D

David G

Well-known Member
We got the new brackets for the Y and Z axis made and installed, now for pulleys.
a271591.jpg

a271592.jpg

a271593.jpg
 
When I worked in the medical instrument mfg business we had one part where the design engineers made a mistake on the type of pulley installed. There were two types; timing and drive pulleys IIRC or something like that. It took me a while to figure out the issue by going over the supplier's specs. One of them is meant to go only in one direction. The other is meant to reverse direction while still holding accuracy. That's the type you're looking for.
 
You must log in or register to reply here.

Similar threads

G
236 Loader brackets
Replies
12
Views
295
stevieb49829
stevieb49829
R
Alternator choice
Replies
7
Views
858
ruschman
R
8
Gordon ???
Replies
2
Views
486
Charles in Aus.
Charles in Aus.
D
Graduated CMC Production specialist today !
Replies
10
Views
384
GermantownGreen
G
Geo-TH,In
Not all 1/2 x 86 inch v belts are the same length.
Replies
19
Views
646
Geo-TH,In
Geo-TH,In
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top