Panel for CNC Mill

David G · Mar 28, 2018

I got the components mounted and wired on the panel tonight.

Tomorrow night, mount in cabinet, this weekend connect.

Janicholson · Mar 29, 2018

Tidy. Jim

David G · Mar 29, 2018

One of the things my company does is design control panels, so personal pride there.

I will post picture once mounted in cabinet tonight.

Oliver 500 Wa · Mar 29, 2018

Off to a professional looking start. Usually more common to see components just laying in an enclosure and a rats nest of wiring and cables. That's one of the things that gripes me when I see most DIY CNCs.

My oldest son has a DIY CNC router and it is like that. Plus the enclosure is almost on the floor under the table. I had to help him once figure out an issue with the e-stop circuit. What a PITA to have to lay on the floor to work on it. Plus it gets filled with dust, dirt and small chips. Sure it saved a bit of space putting it there, but long term it's a bad spot.

David G · Mar 29, 2018

I am mounting cabinet on wall behind mill.

I hate things on the floor, dusty and hard to clean around.

Panel for CNC Mill

David G

Well-known Member

Janicholson

Well-known Member

David G

Well-known Member

Oliver 500 Wa

Member

David G

Well-known Member

Similar threads