Excalibur 2 ton engine hoist

Mike(NEOhio) · May 25, 2017

I need seals for the 8-ton long ram. The hoist is USA made but what was left of the label on the ram said China. Where can I get the parts or repair kit? I'm having no luck on Google.

kcm.MN · May 25, 2017

As a new 8-ton long ram jack can be had on Amazon for $32 with free shipping, I have to wonder if it wouldn't be better to buy a new ram to use while finding parts for the old one.
https://www.amazon.com/Goplus-Manua...1&sr=8-3&keywords=8+ton+long+ram+jack

GlenIdaho · May 26, 2017

A good bearing or hydraulic shop would probably have the seals and O-rings you want. You just need to take the old ones out and match them up. I have the same issue with a 4 ton floor jack, just have to match the O-rings.

Mike(NEOhio) · May 26, 2017

The O-rings are really OK. What I need is the seal where the outer tube meets the base. It's an L-shaped cross section. I'm going to put it back together and see if it leaks. If it does I'll just get that $32 ram.

stonerock · May 30, 2017

can NAPA match them?..columbus seal and bearing? joint and shaft? somebody will match it up

Excalibur 2 ton engine hoist

Mike(NEOhio)

Well-known Member

kcm.MN

Well-known Member

GlenIdaho

Well-known Member

Mike(NEOhio)

Well-known Member

stonerock

Member

Similar threads