Brad Buchanan
Member
Hey folks.
I have my rotary phase converter system up and running with a 3hp bandsaw and a 3hp dust extractor wired in.
I am planning to add a Yates-American J-18 planer with a more modern 3 phase motor and would like to fine tune the run caps to equalize the phase voltages as much as possible. Target voltage is 575.
I would like to set some panel meters for displaying voltage.
My question is should I be measuring phase to phase (this is what I have been doing so far) or would it be more accurate (if possible) to measure each phase to neutral?
This is delta configured.
Sorry if my terminology is not accurate.
Thanks, Brad
I have my rotary phase converter system up and running with a 3hp bandsaw and a 3hp dust extractor wired in.
I am planning to add a Yates-American J-18 planer with a more modern 3 phase motor and would like to fine tune the run caps to equalize the phase voltages as much as possible. Target voltage is 575.
I would like to set some panel meters for displaying voltage.
My question is should I be measuring phase to phase (this is what I have been doing so far) or would it be more accurate (if possible) to measure each phase to neutral?
This is delta configured.
Sorry if my terminology is not accurate.
Thanks, Brad