Adapting Massey Loader to old Kubota

Hey guys I have an Old 1994 B7100HST 4x4 runs and works great just no FEL so after searching high and low for one built specifically for it I finally gave up, but came across a set of D100 loader arms that are brand new just no mount. joystick or bucket.
I went ahead and bought them and they are the right width for my tractor but I need to fab some mounts and a bucket for it so I am looking for plans for a bucket that is 48" wide like the oem bucket does anyone have one the can give me the specs for or a idea of the length to depth to height ratio if there is one?



Thanks
 
I think you cut off a very grizzily piece of meat to chew. Those Kubota weren't overly strong in the bell housing/torque tube area, and most of the dynamic forces of a loader are concentrated there. You will need to do some extensive design work to distribute Those forces forward to the front cast bolster/axle housing, and back to the rear axle/transmission area. Good luck, there is a lot more to a good solid mounting frame than a couple of bolts in the front and a couple more at the rear.
Loren
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top