glennster
Well-known Member
So i have a delta table saw, its a smaller one, not the big unifence one. Anyhoo, i want to make some box joints, 3/4 inch. The stackable dado i
have will only fit about 5/8 inch on the arbor before i run out of threads on the blade mounting shaft. (Arbor). Is there some type of adapter or
extension that goes on the shaft to cut a wider dado? I also have an older craftsman table saw, same length shaft. Really dont want another
table saw. Any thoughts?
have will only fit about 5/8 inch on the arbor before i run out of threads on the blade mounting shaft. (Arbor). Is there some type of adapter or
extension that goes on the shaft to cut a wider dado? I also have an older craftsman table saw, same length shaft. Really dont want another
table saw. Any thoughts?