(800) 853-2651
SHOP NOW

generator

B

brickster

New User
bought a 3 brush generator from yesterday, only has 1 terminal in the back, there are 2 threaded holes where my old one has terminals, do I need to take the new one apart to install the terminals?
 
(quoted from post at 12:07:23 08/02/16) bought a 3 brush generator from yesterday, only has 1 terminal in the back, there are 2 threaded holes where my old one has terminals, do I need to take the new one apart to install the terminals?
Click to expand...
robably need to exchange it for correct generator if you use voltage regulator vs a cut out.
 
You must log in or register to reply here.

Similar threads

M
1939 9N Generator
2
Replies
25
Views
1K
Tim PloughNman Daley RIP
T
D
Wiring universal ignition switch to farmall 504 diesel
Replies
4
Views
274
used red MN
U
T
Ford 8N charging system
Replies
2
Views
411
Tim PloughNman Daley RIP
T
stevieb49829
One wire and 3/2 wire 10SI
2
Replies
27
Views
585
HFJ
H
W
Fuel gauge
Replies
2
Views
298
wildbill447
W
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top