Electric motor from LJD

DH in Carolina · Jan 4, 2015

My thinking: L1 to T2, L2 to T6, Connect T1 to T5, T4 to one side of Capacitor, Other side of capacitor to t6. Centrifugal switch inside of motor will disconnect start winding after motor starts.

Bob · Jan 4, 2015

I agree.

And swap leads between T4 and T5 to reverse motor.

ldj · Jan 7, 2015

(quoted from post at 19:46:41 01/04/15) I agree.

And swap leads between T4 and T5 to reverse motor.

I just got time to connect up by instructions in replys and the motor works good
Another question, there is a smaller black wire that comes up through the Bakelite board that all the other "T terminals" are on. This wire doesn't have a spade connector like the rest, it just comes through a hole in the Bakelite.

Electric motor from LJD

DH in Carolina

Member

Bob

Well-known Member

ldj

Well-known Member

Similar threads