Topic: Re: For Puddles or any of the welders here.
|Tool Talk Discussion Forum|
[Show Entire Topic] [Return to Forum]
[Show Entire Topic]
[Return to Forum]
[Add a Reply]
|Stan in Oly, WA
Yes, 6011. I don't know which is worse any more, my memory or my attention span. Anyway, 6011 is very similar to 6010 except that it has some additives in the flux to make it run on AC, which 6010 virtually won't.
It sounds to me like you did it right and it worked. I didn't understand that the materials you were welding were so lightweight. A job like that is usually quite a challenge. Thin material which burns through easily, deep penetration rod, vertical up where the heat (and the chance of burning through the material) increases as you go. I'd say you could just as easily be bragging about a good outcome as wondering whether you did anything wrong.
|Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]|
| Copyright © 1997-2013 Yesterday's Tractor Co.|
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters