|Tool Talk Discussion Forum|
Re: Front Tine Versus Rear Tine Tiller
[Show Entire Topic]
[Show Entire Topic]
[Return to Forum]
[Log in to Reply]
john *.?-!.* cub owner
I have used both front tine, a large rear tine, a small rear tine, etc. and what you want depends on your use. I have a small tractor with a plow and disk to break the ground, and my preference is a smaller 4 hp rear tine, rotation either forward or reverse, both will do a good job, plus one of the little 2cycles for getting closer to plants, the rear tines are a little difficult to maneuver close to a row. A large rear tine is an advantage for preparing ground, but as plants grow it takes a lot of room to be able to get it between rows.
This post was edited by john *.?-!.* cub owner at 11:57:45 06/02/13.
|Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]|
| Copyright © 1997-2014 Yesterday's Tractor Co.|
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters