Because it is only temporary, only so a buyer can see it run, and NOT put it into service, I would just hook it up to a disconnect and start/stop it by hand. Most likely the pressure switch will not work, so just turn in on to show that it runs and pumps air, then shut it off.
Re: 3 phase Air Compressor wiring - Magnetic starter. in reply to Dusty MI, 04-18-2013 05:34:53
Go ahead my sparky friend, stick your neck out there lol dont be afraid!!!!!!!! I tend to agree if all he wants to do is see it run a short period hook it up direct no need for temporary thermal overload protection, provided he has a quick manual disconnect method handy
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.