It's a DeWalt 14.4 volt cordless drill, model DW991.
Drill has worked flawlessly - until today the chuck shaft stopped turning. Wouldn't turn in either direction. In free air, the chuck would move a little, but had no torque whatsoever.
It was 35 degrees where I was working - a couple hours later I picked it up, and it had usual torque by holding the chuck. I did not test it by drilling or running some screws in.
What failed - healed - ???
Drill has worked flawlessly - until today the chuck shaft stopped turning. Wouldn't turn in either direction. In free air, the chuck would move a little, but had no torque whatsoever.
It was 35 degrees where I was working - a couple hours later I picked it up, and it had usual torque by holding the chuck. I did not test it by drilling or running some screws in.
What failed - healed - ???