Dave Sherburne NY
Well-known Member
Which threading die is best??
High Carbon Steel
Carbon Steel
or what ever else there is?
Been using a Craftsman 1/2" NC hex die on cold rolled steel. It worked better than I expected but last rod threaded didn't seem to fit the nut quite right. I usually just use them as rethreading dies but it's all I had to thread the rods.
I would like to get a good one to use.
High Carbon Steel
Carbon Steel
or what ever else there is?
Been using a Craftsman 1/2" NC hex die on cold rolled steel. It worked better than I expected but last rod threaded didn't seem to fit the nut quite right. I usually just use them as rethreading dies but it's all I had to thread the rods.
I would like to get a good one to use.