What is the correct way/tool to remove the flywheel on an onan CCK 2 cylinder engine? The rope start is bolted to the flywheel with 4 bolts on the one I have. Looks like a plate could be made with four holes in it to match the holes which are used to attach the rope start pulley. Long bolt through the center of the plate to press against the end of the crankshaft. Would have to drill and tap the hole in the plate for the long bolt.
Re: Flywheel removal onan CCK 2 cyllinder in reply to Bob, 10-29-2011 17:39:23
Thank you for the information. The onan I have is 100 miles away from where I live. I have a steering wheel puller like the picture of one You sent. I'll take the one I have when I return to our place in the San Juan Islands.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.