560Dennis
Well-known Member
- Location
- Madison,Ohio
Got this Dynamark snowblower for my son to use . Got it home and look it over . Discover the blade was bent. I got the heated bender backer out , and very carefully bent it back .
- Thread starter 560Dennis
- Start date
OP
OP
560Dennis
Well-known Member
- Location
- Madison,Ohio
About a 5.5 to six inch pitch on this auger . Definitely not a old Ariens ( heavy duty ) but it straightened out . Now got to get the two impeller straight with drive shaft. Probably could let it go but Im to picky unie.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy