stanadyne injection pump parts

Ryankyfarm · Oct 30, 2017

I'm looking for parts for a stanadyne DBGVC429-2DH model 373289R AT16518T
I need the little plate that's on the fuel inlet it goes between the top and the vanes of the pump some call it a wear plate unless my model of pump didn?t have one?
but the youtube videos I have seen on disassembly shows the plate
could it have been removed for performance? (more fuel)
I also managed to break my advance screw (common problem)
this goes on a john deere 2010 4 cyl diesel

ronhf · Oct 30, 2017

I got parts for my 4020 pump online from a place called "highway and heavy parts." They are located in MI.

thepumpguysc · Oct 30, 2017

You pump doesn't use the wear plate. UNLESS its been updated.. if so, it'll have a large diameter cut*out to fit the plate.. & the regulator will be on TOP.. BUT I think your is on the SIDE & is FLAT so, no it doesn't carry the plate.

The OLD cam screw P# is Stanadyne 15438.. just put it in google.. lots of choices.
Probably cheaper to get it local..

Dieseltech · Oct 30, 2017

As thepumpguy said, there are two end caps used. Early used NO wear plate and MUST use the carbon style blade pair, early cap also had a 1/4 inch pipe thread pressure tap port. Late end caps did use the wear plate, had the 1/8 inch pipe thread pressure tap port, with the four piece blade set with springs..

Ryankyfarm · Nov 17, 2017

Well after a long wait for the shop to check it out this little pump is pretty well shot oregon fuel injection said no core value would cost more than the tractor is worth to rebuild is there some type of conversion for a different more updated pump from what i have gathered these pumps are getting scarce?
I'm lost as to what to do my pump number is dbgvc429-2dh

crowfood · Dec 2, 2017

(quoted from post at 04:33:49 10/30/17) You pump doesn't use the wear plate. UNLESS its been updated.. if so, it'll have a large diameter cut*out to fit the plate.. & the regulator will be on TOP.. BUT I think your is on the SIDE & is FLAT so, no it doesn't carry the plate.

The OLD cam screw P# is Stanadyne 15438.. just put it in google.. lots of choices.
Probably cheaper to get it local..

I'm new and learning a lot thru reading your posts. I have a roosa master DBG injection pump. Wanting to install a 16320 pilot tube. Stanadyne service bulletin says use epoxy p/n 46737 or epoxy kit p/n 46739. If I must use this epoxy, where can I get it, or will Loctite 620 sleeve retainer compound suffice? Appreciate any HELP.

stanadyne injection pump parts

Ryankyfarm

New User

ronhf

Member

thepumpguysc

Member

Dieseltech

Well-known Member

Ryankyfarm

New User

crowfood

New User

Similar threads