(800) 853-2651
SHOP NOW

john deere 2010 row crop clutch tool

R

Ryankyfarm

New User
I have been surfing these forums for many years so i figure I should just join so I did so here I am fellow tractor mechanics

I'm working on a john deere 2010 diesel tractor clutch i have done a few of the crawler steering and engine clutches on the MC's and 440 john deere
I have read this post on http://forums.yesterdaystractors.com/viewtopic.php?t=348555
I have the tool used for the mc and 440 clutch I was wondering if it would work or can I use a tape measure and measure the 2-1/8 on the fingers?
I have heard 2010 clutches can be finacky when it comes to this measurement
 
I have always just measured. Infact I
try to get them a little different.
Makes engagement smoother. At least
..060 I think it works. I can tighten the
chain on a pulling sled like I had a
hydro. Its a 435 JD.
 
I have always just measured. Infact I
try to get them a little different.
Makes engagement smoother. At least
..060 I think it works. I can tighten the
chain on a pulling sled like I had a
hydro. Its a 435 JD.
 
You must log in or register to reply here.

Similar threads

J
John Deere 2010 Crawler diesel Main bearings
Replies
5
Views
483
Lavoy
L
S
john deere 2040 clutch
Replies
1
Views
323
Jim.ME
J
Kengram
4020 John Deere Hydraulic Problems.
Replies
15
Views
564
Tx Jim
Tx Jim
A
John Deere 730 clutch fork spring
Replies
1
Views
290
730 virgil
7
T
John Deere 440 Starter
Replies
3
Views
363
Randy G.
Randy G.
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top