Greetings from a "silver-back", new member.
I'm about to overhaul a set of hydraulic controls that were on a home-built machine that I acquired. Unfortunately, it has many unbranded sub-systems, and one of them is a 6-spindle hydraulic control control block (1-piece) that is likely (IMO) from an old dozer or backhoe. I need to buy new seals (etc) for it, but I must first find out who made it. I'm going to attempt to post some images of it in the hope that someone will recognize the manf.
If I have trouble getting the image posted then plse check back as I'll try again very soon (today).
Thanks in advance.
Link to pics below:
http/www.byfieldwelding.com/yt/IMG_8159_v1.jpeg
http/www.byfieldwelding.com/yt/IMG_8160_v1.jpeg
http/www.byfieldwelding.com/yt/IMG_8161_v1.jpeg
I'm about to overhaul a set of hydraulic controls that were on a home-built machine that I acquired. Unfortunately, it has many unbranded sub-systems, and one of them is a 6-spindle hydraulic control control block (1-piece) that is likely (IMO) from an old dozer or backhoe. I need to buy new seals (etc) for it, but I must first find out who made it. I'm going to attempt to post some images of it in the hope that someone will recognize the manf.
If I have trouble getting the image posted then plse check back as I'll try again very soon (today).
Thanks in advance.
Link to pics below:
http/www.byfieldwelding.com/yt/IMG_8159_v1.jpeg
http/www.byfieldwelding.com/yt/IMG_8160_v1.jpeg
http/www.byfieldwelding.com/yt/IMG_8161_v1.jpeg