IH rear hub cast weight brackets

feverpuller · Apr 17, 2018

Anybody on here make rear wheel weight brackets for cast hubs on a IH M or 560? The kind tgat are made from like 6" c channel and you just slide the weights on and it'll hold like 6 sets.

Dblair · Apr 18, 2018

here's my brother pulling out 450 with those brackets , they hold 6 on a side

Dblair · Apr 18, 2018

here's what a section looks like with the 4 inch channel and 3/4 round welded on the corners to fit a farmall wheel weight .

feverpuller · Apr 19, 2018

Yes that's what I'm talking about right there!
How do they mount to the hub?
Any closer pics with the weights removed?
Thanks dblair!

Dblair · Apr 19, 2018

they are just welded to a 3/8 plate in the back and one on the front both have a axle hole and the rear one bolts to the weight holes . everything has to be real square .back plate is 3/8 x 6 x whatever . front is 3/8 x 4 x whatever . I'll look and see about the pics but I doubt it .

feverpuller · Apr 20, 2018

Thanks dblair

Welding man · Apr 20, 2018

I use 3/8 or 1/2 in plate,cut a donut and weld the channel to it . I use 5 in channel. I have made several sets for other pullers. I personally use Oliver and Cockshutt weights and just roll up a piece of pipe the right size and attach it to the lug bolts.

Dblair · Apr 21, 2018

yea that sounds like a good plan , I used 4 inch because that's what I had .

IH rear hub cast weight brackets

feverpuller

Member

Dblair

Well-known Member

Dblair

Well-known Member

feverpuller

Member

Dblair

Well-known Member

feverpuller

Member

Welding man

Well-known Member

Dblair

Well-known Member

Similar threads