(800) 853-2651
SHOP NOW

Trany clutch WD Allis

I guess no one has done this. I think our WC will shear 2 - 3/8 bolts. Zack petersons book has a picture of a WD with a WC trans in front. If get to it I'm going to do this.
 
I seen that article also, looked like a interesting project. We are putting in a 45 crank and 1/8 over bore pistons, just want to make sure that clutch doesn't start slipping. Thought drilling and bolting would be easier than replacing with shaft and couplings.
 
If clutch is good will hold it. But with snapped in a couple bolts would really hold it. I was probably wrong. But if are going to pull it. I would take it out anyway.
 
You must log in or register to reply here.

Similar threads

M
4230 rear axle noise
Replies
2
Views
220
Moos
M
W
B414 Torque Setting
Replies
1
Views
225
used red MN
U
C
Carburetor Sizing and Manifold Modifications
Replies
6
Views
947
CFS Carbs
C
K
Dearborn Plow 10-80 U-bolts
Replies
2
Views
206
caterpillar guy
C
R
ford 4400 head bolts
Replies
9
Views
376
showcrop
showcrop
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top