jd50 puller
Member
Its been roughly 10 months since I have contacted a shop about getting some parts made for the engine in my 50. Sent rods out to get lengthened also sent the camshaft. Also was getting new pistons. Well in the corner of my shop sits my 50, in pieces as it has for the last 10 months. My question is there anyone reputable that can get me parts in a reasonable amount of time that will make decent power ( I know its just a 50 but for all they are they still are pretty good little pullers). The crank is already offset ground and the block is rough bored but not finish honed. Any help would be appreciated. Ready to cut my losses and get this thing back together.