looking for pic of making a stroked crank for a farmall

Anonymous-0 · Apr 21, 2013

So this wknd a buddy of mine and I were disscusing how some guys do it.....I know I"ve seen pic on here but was wondering if u guys would post on here again....thanks

EP · Apr 22, 2013

Super pinky you can do a search using words "stroker crank pics" in this forum. I haven't made any more progress but am hoping to get back at it shortly and post more pics.I don't claim to be an expert but I've had good luck doing it this way.how much stroke do you want to add?ep

Anonymous-0 · Apr 22, 2013

Ya I was searching for them but can't find the pic I remb......it was really neat how it was reinforced and cut and lengthened..... I was thinking about taking my 450engine to 6.5....from what I read that's about the further u can go.....next winter I want to tear mine down and get it to push 90-100horse

EP · Apr 22, 2013

if you are going to the trouble of stroking.i would go to 7 inch at least.i went to 7.125 for something a little different.you can also go to 7.250.some people say you don't gain a lot over the 7.250 mark. at 6.5 you should go to a custom rod anyway so you may as well get the extra cubes,it wont cost you any more $.that's my 2 cents for what it's worth.

FactoryFarmer · Apr 22, 2013

Text me I have all the pictures on my phone: 815-858-4529

Anonymous-0 · Apr 22, 2013

OK factory farmer .....thanks

FactoryFarmer · Apr 22, 2013

I'd post them here but I'm not sure how to upload then to the forum from my phone.

jd b puller · Apr 22, 2013

I've done several at 7" using stock rods (narrowed).

looking for pic of making a stroked crank for a farmall

Anonymous-0

Well-known Member

EP

Member

Anonymous-0

Well-known Member

EP

Member

FactoryFarmer

Member

Anonymous-0

Well-known Member

FactoryFarmer

Member

jd b puller

Well-known Member

Similar threads