Massey 44 pics

jd b puller

Well-known Member
Not sure where the thread went the other day about the Massey pistons.

Here's the 4.5" block. Pistons should be done in a couple weeks.
Someone asked about a 4" or 4-1/16", can do that as well.
16284.jpg
16285.jpg
16287.jpg
 
My gosh look at the meat in that block. 4.5 safe or is more just
a matter of time when it comes apart?
 
Dblair, this one is 100cc. i think it"s .600" tall. We hit the dome limit on the ones for you a while back because of the compression height. Only so much forging to go around.
 
thanks Ray , I might be coming down some this year . I think it will be the State Fair at Raleigh
 
that's a healthy engine . looks to me a 1" stroke
may yield 120 hp on a 4500 pound machine . should be
a whole lot of fun.
 
(quoted from post at 23:15:06 03/30/13) that's a healthy engine . looks to me a 1" stroke
may yield 120 hp on a 4500 pound machine . should be
a whole lot of fun.

This one is stock stroke, but yeah, has a lot of potential once you get the air into it... Heads and manifold leave a lot to be desired.

Sleeves have a little lip at the top and blended in nicely.

Be good to see you at Raleigh Dave, hopefully I'll have the Little B back together by then. It's getting a few "enhancements".
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top