Farmall H puller ( C bolster)

The Gambler pulling team · Dec 12, 2012

What is your opinion on putting a farmall C spindle assembly on a farmall H. Is the spindles strong enough or should I use trailer spindles with the Farmall C bolster.

nl00sb · Dec 12, 2012

we have one that pulls into 5500 and comes down pritty hard from time to time never had a problem

mshultz · Dec 12, 2012

We take our H to 9000 with one on and it holds. We also had one on our M with a turboed 407 that we took to 10,000 and it held up on that too...

On at least one of them I know we needed to weld some ears on it to make the base big enough to bolt up with the bigger tractor.

A homemade tube might be a little stronger, but I think the C front is plenty strong - just don't go plowing with it. We prefer the look of the C front to the tin also, but to each their own.

Anonymous-0 · Dec 12, 2012

was thinkn of douing the same thing does anybody know the difference in weight between the two bolsters thanks

CGpuller · Dec 15, 2012

I used the B/C bolster with 4 bolt trailer hubs and spindles. It works well.

1UpFabrication · Dec 27, 2012

If it uses the same lower bolster as the "M", I have Custom Lightweight units that only weigh 32lb and are on quiet a few Farmalls and have pulled up to 10,000lb classes with a 1000 hanging out front and have yet to have any problems!! Give me a call if you are interested at (423)736-4080 I have them on the shelf ready to ship for $285 shipped...This price stands good for all orders recieved by 12-31-12

Farmall H puller ( C bolster)

The Gambler pulling team

Member

nl00sb

Member

mshultz

Member

Anonymous-0

Well-known Member

CGpuller

Member

1UpFabrication

Member

Similar threads