Wd 45 Stroke

Anonymous-0 · Dec 7, 2012

Is it possible to stroke a wd 45 to 5inches and use my stock rods. If so what pistons could I use. Thanks

ss409 · Dec 7, 2012

seen em at 5.5 with stock rods with light clearence work on the cam.

bp4455 · Dec 8, 2012

if you do 5.5 you will have to cut out sections of the oil pan and weld cups on it. that being said, i dont think 5" is enough to bother with a welded crank. you can get 4.875 with an offset grind and buda rods.

Allis puller · Dec 11, 2012

Yes you can. also i have an allis puller with a 7" stroke and the only clearance work i done was in the block which wasnt much.

Anonymous-0 · Dec 12, 2012

(quoted from post at 17:31:39 12/11/12) Yes you can. also i have an allis puller with a 7" stroke and the only clearance work i done was in the block which wasnt much.

dont take this as me saying you dont have seven inches of stroke cause you may have but if you have left the mains in the original place then you have had to do some major clearancing . here is a picture of the oil pan rail on a 6 inch stroke .

Wd 45 Stroke

Anonymous-0

Well-known Member

ss409

Member

bp4455

Member

Allis puller

New User

Anonymous-0

Well-known Member

Similar threads