|Antique Tractor Paint and Bodywork|
Re: Paint Finish Textured - What Happened? Need some Help
[Show Entire Topic]
[Show Entire Topic]
[Return to Forum]
[Log in to Reply]
Basically.....most of the cast iron came out pretty well....it seems a little dull for the finish, but smoothed out nice. The sheetmetal is where I had the most trouble.
I did wet sand the gas tank (with original paint and no primer) just so it would "match" the rest of the sheetmetal. Like I said earlier, I'm no professional, but I "thought" that would help.
The fenders were not wet sanded however were cleaned up with some 220 sandpaper.
The fenders, gas tank, hood, and front cowl/grille all came out like you see in the pictures of the gas tank, etc.
This post was edited by RTR at 07:00:59 09/24/13.
|Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]|
| Copyright © 1997-2016 Yesterday's Tractor Co.|
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters