(800) 853-2651
SHOP NOW

Oliver 77 industsial

C

Case Puller

Member
Looking at a Oliver 77 industrial and was wondering how fast the road gear is in it.Do all the gear speeds match close to the 77 standard?
 
   77 Standard has 3.44:1 pinion to ring gear ratio.   77 Industrial has 4.16:1 ratio.  

At rated engine speed travel speeds are:

Industrial 1200x24" tire
5th 10.11 MPH
6th 17.60 MPH.

Standard 13.6 x 26" tire
5th 7.10 MPH
6th 12.37 MPH.   There are only two gears in the transmission that are different, however to install them it requires a complete teardown of the tractor (they are on the pinion shaft).

   I assume that you are looking for something for tractor rides, Take the rear end off of a Row Crop, then marry the Industrial rear end to the front frame of the Row Crop, install the axle/housing from the Row Crop and the 38" rear rubber and you have a 22 /23 MPH ride @ rated engine RPM.

   I have a 77 Standard (higher speed ring and pinion) with the Industrial gears, 16.9x26' tires and a 1650 engine, hang onto your hat, it's 30 MPH on my GPS Garmin all day long, hills do not bother it!   I installed all new tie rod ends and all new crosses in the steering joints.
 
Thanks BA. That is the info I needed.Thinking of taking the industrial on a tractor ride and was wondering if I could keep up with a 12-15 mph pace.Thanks again for the info
 
(quoted from post at 15:28:32 08/17/17) Looking at a Oliver 77 industrial and was wondering how fast the road gear is in it.Do all the gear speeds match close to the 77 standard?
Click to expand...
Just my opinion but please don't tear apart a 77 industrial to make a race tractor they are a pretty rare piece I'll rescue it and trade you a 17 mph standard for it !!!
 
You must log in or register to reply here.

Similar threads

C
Bosch Pump oliver 77, 88 diesel
Replies
8
Views
729
flooder1997
flooder1997
D
Oliver 77 Sealed Beam Worklight
Replies
7
Views
432
DLWalter
D
Steve Metcalfe
Oliver 77 front hub interchangeability
Replies
1
Views
209
Gary Mitchell
Gary Mitchell
B
Oliver vs Farmall and JD Gas Mileage
2
Replies
30
Views
2K
buickanddeere
B
C
Oliver 77 standard
Replies
7
Views
370
J.Wondergem
J.Wondergem
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top