Cockshutt 290 plough

550Doug

Member
Location
Southern Ontario
I'm looking for shares, shins and moldboards for my 290 3 furrow 16 inch plow.
The number on the back of the moldboard is P11569 and it may have been made by David Brown.
The parts book calls it a 14 inch 234A bottom.
It's quite likely that P11569 would cross over to a Melroe/Oliver/David Brown number but I'm not having any luck in finding one.
Any ideas?

mvphoto1084.jpg


mvphoto1085.jpg


mvphoto1086.jpg


mvphoto1087.jpg
 
plow share bolt placing is measured from the front, use a straight edge to align all the
bolt holes and then measure from the front. From the front edge of the share to the center
of the first hole will be your first measurement.

I did a quick look through some of the most popular shares and the deepest measurement from
the top of the share to the center of the holes are 1 inch, nothing using a share with the
measurement of 1 1/4.

need that first measurement to help you .
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top