(800) 853-2651
SHOP NOW

Calling John Schwiebert

S

StrongsOlivers

Member
I have quick question. Do you know if anybody had a 1365 with a loader and had it on 30 inch centers? Right now mines set for 31.5 inches according to the book, but the rims have been changed since new. I roughly measured from the center of the tractor to the center of the tire and got 33 ish inches, but it's a bit chilly out so I wasn't to precise.
 
Yes, we had 1 customer that did. That tractor was on a cultivator a lot. I don't remember what size tires the tractor had. It has been gone for probably 15 years!
 
Shoot. I was gonna take a tape measure out with me and measure mine when I went out and bedded cattle but I forgot it. It's in there pretty narrow.
a247957.jpg
 
I drove mine down some corn rows today and it close,there Would be no room for error. Also I noticed your loader brackets are further in than mine. I'm going to try to move them in tomorrow and see, I'll get pictures to.
 
I remembered to measure mine. Dead center of one rear tire to dead center of the other is 56 inches. They clear the loader frame by about two inches on each side. That's on a 1524 loader.
 
You must log in or register to reply here.

Similar threads

F
620 John Deere crankshaft tolerances
Replies
19
Views
683
Fidlstyks
F
G
update Kohler Blowing oil--long
Replies
7
Views
1K
buickanddeere
B
J
MF 202 wheels and tires
Replies
4
Views
1K
jon_schram
J
D
Mounted Cultivator spacing on B Farmall
Replies
4
Views
1K
Don Hopf
D
M
making a White 2-105 run 4 30 inch rows
Replies
1
Views
409
CumminsMan
C
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top