2150 restoration

larry duda · Dec 14, 2016

Finally working on the 2150 again. Have the rearend, axles, transmission,brakes and drop box rebuilt and back together.

super99 · Dec 14, 2016

Wow, that's gonna be good as new when your done!!! Back in a former life, I had a 2150 FWA, They are one impressive tractor to run. I had trouble with the top seal in the drop box leaking rear end oil into the drop box and overfilling it, you might want to check that bottom shaft over real good if it's not too late. Chris

big tee · Dec 15, 2016

WOW Larry-when you restore something, you RESTORE it. You don't just put lipstick on it. Looks good---Tee

larry duda · Dec 15, 2016

This tractor was a basket case when I bought it. So far I have rebuilt brakes with all new discs,balls,springs and seals. All new PTO clutches, seals, shims,and half the bearings. New axle bearings and seals. Replace one rear axle bull gear and the Transmission countershaft, all new bearings in the transmission.All new bearings and seals in the transfer drive. Where ever there was a seal or oring in the rear assembly it was replaced. Working on the hydraulic system now. Replaced both external lift cylinder pistons because they were pitted from setting outside with 3 point lift up. Put all new seal kits in the cylinders. Don't know the true status of the hydraulshift or front drive axle other than the 3 speed shifted and I could spin the front tires when I put the tractor front against a large tree. When I get the rear done and the tub back on I'll do the 3 speed and the front axle. The engine is another story for later. Will continue posting as progress continues.

2150 restoration

larry duda

Member

super99

Well-known Member

big tee

Well-known Member

larry duda

Member

Similar threads