1650 hydraulics gasket

Cleon Couey · Nov 1, 2016

Hydraulic oil leaking into rear end. Pump was just changed.Had to remove cover again because pto shaft was stuck. Isthere something I can put on the flange instead of $67 worth of gaskets?

Mike(NEOhio) · Nov 1, 2016

I reused my gaskets last year and they worked OK. I laid them on a piece of plywood and went all around both sides with solvent on a rag then cleaned up any rough spots. Then made sure the pan was nice and flat around the flange. Both gaskets had some damage but I put the better one on top of the pan. I just had it off again to change the shift rod. I think the only place it could leak into the rear end is the case wall below the filter or a hole in the pan. Anywhere else would leak outside. I suppose a little blue glue couldn't hurt as long as you don't have to take it off again.

Cleon Couey · Nov 1, 2016

Thanks Mike. I went ahead and ordered 2 new gaskets since it's the neighbors tractor. $90 ($20 shipping).

Mike(NEOhio) · Nov 2, 2016

Three years ago they were $19. I was going to get new ones when I took mine apart last year and they were $32 so I was real careful taking them off.

1650 hydraulics gasket

Cleon Couey

Member

Mike(NEOhio)

Well-known Member

Cleon Couey

Member

Mike(NEOhio)

Well-known Member

Similar threads