(800) 853-2651
SHOP NOW

What Shanks will fit a 285 feild cultivator

S

StrongsOlivers

Member
I'm looking at a 285 that is missing some shanks anyone know of any other cultivator shanks that will fit? Any besides brillion and glenco.
Thanks
 
Lots of 285/485 field cultivators laying in the weeds. Should not be a problem finding the shanks for them. Don't forget they are a two piece that are sandwiched together, and try to get the special lower washer button that goes along with them. IIRC all parts are still available from AGCO if you do wish to go that route.
 
Do you need just the spring shank, or the whole assembly? Depending on where your located I have a 485 that I'm cutting up for scrap because all the pivots are wore out on it and not worth my time to rebuild, but most of the spring shanks are in good shape yet. I'm in northwest ohio
 
What I ment is would you sell the wings? Cause I'm getting 18 ft and would prefer wider, so I'm in the
market for bigger wings. My email is open.
 
You must log in or register to reply here.

Similar threads

S
Chisel plow point ?
Replies
8
Views
394
Fixingfarmer
Fixingfarmer
S
Chisel plow ?
Replies
6
Views
774
paul
P
J
Coil tine field cultivator for a CA Allis Chalmers
Replies
6
Views
524
J.T. Blanton
J
O
Oliver 1850
Replies
7
Views
429
Oldoliver1850
O
T
MF 285 .v. 1085 Cab
Replies
6
Views
596
lugnuts2030
L
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top