(800) 853-2651
SHOP NOW

Cockshutt 40 input shaft seals

G

Gearhead210

Member
Without much luck I haven't found a whole lot of information about what seals are on the transmission input shaft for a 52 Cockshutt 40 with live power. It must have seals inside the snout coming off the front of the transmission, and needle bearings supporting the outside shaft. Anyone have any part numbers for the 2 seals? Agcopartsbooks doesn't list anything in there for seals. Any help appreciated,

Thanks
Richard
 
I sent you an email. There are no seals on that shaft, just a bearing on the rear end. The front end pilots in the flywheel coupling. PTO drive shaft is supported at the flywheel coupling and PTO end. Is yours leaking?
 
Hi,

Mike is correct!!!!

The spiral spring on the live PTO shaft is approx. 12 inch wrapped around the shaft under the trans. cover. This spring serves as an oil slinger to keep trans. oil from following the shaft forward to the clutch. ONLY,the Cockshutt 500 series tractors use a front trans. seal.

Phil Heisey
215-256-8651
 
if you have pulled the pto and pto drive shaft using the tractor for a puller you will need to plug the torque tube in order to prevent oil from getting into the flywheel clutch area. Also do not overfill the rear-end with gear lube.

www'cockshuttdecals.com
 
You must log in or register to reply here.

Similar threads

G
Ford 861 input shaft seals
Replies
6
Views
375
used red MN
U
O
Oliver 1655 Over/Under Input Shaft Wear
Replies
2
Views
407
buzzinduzzin
B
P
Cub bent input shaft, questions?
Replies
8
Views
371
BarnyardEngineering
BarnyardEngineering
D
In search of of cockshutt 40
Replies
0
Views
210
Dabigc3
D
C
Super C input shaft seal replacement
Replies
1
Views
104
Charlie M
C
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top