Anonymous-0
Well-known Member
Looking for head bolt and main bolt torque specs.
- Thread starter Anonymous-0
- Start date
Phil Heisey, Harleysville
Member
Hi,
G3400 head..........175 ft. pounds for all EXCEPT #11 and #13 on tightening sequence...which are 160 ft. pounds......These two are at each end of the widest end of the head.
G3400 mains:
"T" stamped caps.........9/16' = front, rear, & intermediate = 130 ft. pounds.........1/2'center main = 100 ft. pounds
PLAIN CAPS (NOT T stamped)...........80 ft. pounds.........ALL Caps!
Phil Heisey
215-256-8651
G3400 head..........175 ft. pounds for all EXCEPT #11 and #13 on tightening sequence...which are 160 ft. pounds......These two are at each end of the widest end of the head.
G3400 mains:
"T" stamped caps.........9/16' = front, rear, & intermediate = 130 ft. pounds.........1/2'center main = 100 ft. pounds
PLAIN CAPS (NOT T stamped)...........80 ft. pounds.........ALL Caps!
Phil Heisey
215-256-8651
Anonymous-0
Well-known Member
Thank you phil
keith gordon
Member
hears a pic
Anonymous-0
Well-known Member
Thank you Keith. I hope to have this engine done for the bluegrass super pull will you be there? I also have a question is there a number I can reach you at?
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy