Well, here"s what I use.
For wet sleeve motors my basic puller is a piece of 3/4 all thread. Those sleeves stick out the bottom so all you need is a plate a little bigger.
For the top you need something to span the top of the block to pull from and it needs to be held up some for the sleeve to rise. I use a couple of broken pieces of anhydrous shank. The piece I use to span the block came off a 2388 and was what the shaker are pivoted off of.
I"ve pulled 3306 sleeves with this with a different bottom piece. I will admit it wouldn"t pull the sleeves out of the 80 I am helping on but that was a whole different case.
If I need something tougher I will build it. But unless yours are corroded like that 80 I think it will pull it.
RT (My 2 cents)(it"s cheap and works)