(800) 853-2651
SHOP NOW

60 Oliver row crop

You need 10 under bearings.When a crank is ground the bearings need to be undersize because the mains and crank pins are now undersize. The rod bearings are the same as for a 66 or 77 Fleetline tractor. For the main bearing set you will need to have a couple of oil holes relocated. Now the thrust on a 60 only has a flange on one of the shells. . There are several ways you can do this. Wait till tomorrow and I will get you both the Clevite and the F-M bearing numbers. Any other questions? We have a 60 engine apart at work right now so I can look if I need to.
 
thank you for the info. I wood like any info. you can give me. how do you tell what engine you have, there are cast numbers 160120e ,D158, ser. 624620
 
Call Maibach Tractor in Creston Ohio. They are the 60 tractor specialists. They had everything on hand when I overhauled my 60. The original sleeves and pistons are NLA through Agco. They custom make a sleeve and use a larger Continental piston. The rod bearings are the same as early 66. The mains might be the same basic size too. The mains I got for mine from Maibach had another oil hole drilled in them.
 
You must log in or register to reply here.

Similar threads

T
Oliver 60 muffler
Replies
7
Views
685
J.Wondergem
J.Wondergem
waugh621
38-14 9 bolt rims
Replies
0
Views
100
waugh621
waugh621
P
TD9 Main Bearings (1948 Diesel Crawler)
Replies
4
Views
307
John Deere D
John Deere D
J
8N rebuild
Replies
3
Views
399
Jeff Jones Tucson
J
J
Need help with John Deere 1010w 4 Cylinder gasoline Main bearings
Replies
7
Views
305
used red MN
U
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top