parts to build a 310 pulling engine

PCH · Jan 23, 2013

Avy one know where I can find a exhaust manifold with a center dump that will fit the 310?Does any one make a engine kit other than standard for the 310 that would increase horsepower? Just trying to figure out what direction Im going to take the engine. Thanks

Anonymous-0 · Jan 24, 2013

Darton makes a sleeve that drops into the factory block and increases the bore size to 4.060. They are ductile iron and cost about 130.00 each. With a stock stroke crank you will have 340 cubic inch. Your gonna have to make a stock manifold dump in the middle or just run a S shaped pipe back through the factory hole in the hood.

Ollie Oliver · Jan 25, 2013

and quarter inch steel side panels when rods start flying.

parts to build a 310 pulling engine

PCH

Member

Anonymous-0

Well-known Member

Ollie Oliver

Member

Similar threads