|
| |
| Oliver, Cletrac, Co-op & Cockshutt Tractors Discussion Forum |
Topic: Re: timming on oliver h-g cle-trac
[Show Entire Topic] [Return to Forum]
| Author |
[Modern View]
|
| Hank
01-07-2013 15:54:45
24.110.23.134
|
Correct mag timing is 14 degrees or 1 15/16 inches before top dead center, which is the same as "SPK" mark on the flywheel. Before installing mag make sure rotor is timed to drive gear. Turn drive coupling in opposite direction of normal rotation until white line on rotor shows in center of distributor cap window If flywheel "SPK" mark is in center of bellhousing timing hole, mag coupling should align with hole.
|
|
|
|
| Hank
01-07-2013 15:59:56
24.110.23.134
|
|
Re: timming on oliver h-g cle-trac in reply to Hank, 01-07-2013 15:54:45
|
|
| last line should have read magneto coupling should align with DRIVE not hole. sorry for type o
|
|
| [Show Entire Topic]
[Options]
[Printer Friendly]
[Return to Forum]
[Add a Reply]
| Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ] |
Home
| Forums
Copyright © 1997-2013 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters |
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
|
|
|
