(800) 853-2651
SHOP NOW

Draft control spring yoke missing pin

M

Milesvdustin

Member
So I am missing the pin that connects the rocker NCA535A to the draft control spring yoke. None of the pictures in my FO-4 manual show this pin with a number. It does show on page 135 figure 195 the bottom rocker pin 8N486A (that's the one to never remove, right?) but not the other pin. On page 145 figure 208 it shows a pin with a cotter key, but no number or part number for it. That page lists the bottom rocker pin as 8N486B.

On page 91 figure FO138 it shows a pin labeled "P" that is the lower pin, I need the one above it.

What type of pin do I need for the control spring yoke to rocker connection?
 
(quoted from post at 15:31:05 05/17/16) So I am missing the pin that connects the rocker NCA535A to the draft control spring yoke. None of the pictures in my FO-4 manual show this pin with a number. It does show on page 135 figure 195 the bottom rocker pin 8N486A (that's the one to never remove, right?) but not the other pin. On page 145 figure 208 it shows a pin with a cotter key, but no number or part number for it. That page lists the bottom rocker pin as 8N486B.

On page 91 figure FO138 it shows a pin labeled "P" that is the lower pin, I need the one above it.

What type of pin do I need for the control spring yoke to rocker connection?
Click to expand...
ife is so complicated? Whatever fits the hole.
 
If I understand correctly, the part you want is the pin that holds the rocker to the yoke. At the New Holland online parts store, this is described as: "Clevis, Rocker to Yoke, 3/4" x 3.14". Their part number is 86521836. (I usually start there because of the online catalog -- it has really good drawings.)

The part is available from our hosts -- http://www.yesterdaystractors.com/352625S8_Pin-Hydraulic-Lift-Rocker_17254.htm

The description there is "Lift rocker pin to rear end housing. 3/4" x 3.14". For tractor models 9N, 2N, (1939-1947)." However, this is the same pin.
 
You must log in or register to reply here.

Similar threads

L
1950 8N Yoke Pins
Replies
5
Views
544
Louis44
L
W
What is the purpose of the pin in a draft control spring plate on a Jubilee
Replies
5
Views
540
Winch
W
C
800 hydraulic pump confusion....problem?
Replies
4
Views
409
Centerline
C
N
how to tighten the draft control spring?
Replies
9
Views
2K
jimtrs
J
W
9n draft control spring bolts
Replies
1
Views
439
Den N Ms
D
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top