buckfever40
New User
i need to know if the rims from a ford 3600 will bolt to an 8n. thanks in advance for the info.
- Thread starter buckfever40
- Start date
Paul in MN
Well-known Member
By the time the 3600 was built, there were tire and wheel options, so they are not all the same. The common wheel rims for the 8N are 28" diameter and have 6 loop mounting lugs. (Ya, I know the hat rims were original, but the 6 loop 28" rims have replaced most of the rusted out hat rims). The rim width is not critical, but 9", 10", and possibly 11" widths will fit. So there is some possibility that rims off the 3600 might fit, but don't bet on it. Check their size, and then make your decision.
Paul in MN
Paul in MN
Ultradog MN
Well-known Member
- Location
- Twin Cities
Yes.
24" tires were optional after 1965. But I would guess that 90% of them came with 28s which would bolt onto his centers.
More troubling to me would be the fact that his N needs 10x28 rims and a 3600 would use 12x28. That's 2 sizes bigger and sad but true, not a fit for his tires.
24" tires were optional after 1965. But I would guess that 90% of them came with 28s which would bolt onto his centers.
More troubling to me would be the fact that his N needs 10x28 rims and a 3600 would use 12x28. That's 2 sizes bigger and sad but true, not a fit for his tires.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy