Walston
Member
- Location
- Upstate SC
I wired my Jubilee project using a nnalert 12 volt conversion. I used this diagram:
My starter button does not work. I have to jump from the + battery side to the side of the starter solenoid where he shows the white wire. Then the tractor starts. Going to the negative side does nothing, just like the starter button.
I am assuming that the starter button goes to ground, so any ideas on what I may have wrong?
My starter button does not work. I have to jump from the + battery side to the side of the starter solenoid where he shows the white wire. Then the tractor starts. Going to the negative side does nothing, just like the starter button.
I am assuming that the starter button goes to ground, so any ideas on what I may have wrong?