Hobo,NC
Well-known Member
- Location
- Sanford, NC
I had a Guy clear off some land for me when it came time to settle up he wanted to trade the work out. I did my best to pay him so I did have not work on this P.O.S. I did not know it was a total loss that was being resurrected :twisted: It has set outside for years all the screws etc were broken off. There is probably a gallon bucket of various sheet metal screws holding the interior together (just kidding but you would think it). The fun part they hand built these cars nuttin fits you have to make it fit... To make it worst a 68 Vette is a one off there are allot of things they redesigned after that (for the better but they are all a P.O.S.... In most cases I had to make the later stuff work... I Found the piece I was looking for today "The Last Damm Piece" It was the horn button
He has to get someone to do some work on it so I can get the drivers side rear quarter panel something to bite to... The Wiper door mounts are broken out of the fiewall I told him to get it to his house I will pull it out and rework the linkage he then could get a good body man to fiberglass the supports back in...
This is the 5th one I have done I hope its my last... This is how I got it... It has set on one on my lifts 4 mounts I have about 100/115hr. of time into it...
I did leave out the part somewhere along the line the clutch blew apart and cam threw the floorboard warping the ell out of everything in its path...
Done, he's spose to haul it off tomorrow afternoon... 1968 Corvette 427 4 speed...
He has to get someone to do some work on it so I can get the drivers side rear quarter panel something to bite to... The Wiper door mounts are broken out of the fiewall I told him to get it to his house I will pull it out and rework the linkage he then could get a good body man to fiberglass the supports back in...
This is the 5th one I have done I hope its my last... This is how I got it... It has set on one on my lifts 4 mounts I have about 100/115hr. of time into it...
I did leave out the part somewhere along the line the clutch blew apart and cam threw the floorboard warping the ell out of everything in its path...
Done, he's spose to haul it off tomorrow afternoon... 1968 Corvette 427 4 speed...