I ordered a new PTO seal (part D9NN703BB) and it's quite a bit thinner than the old one I drove out, so much so that there is no way it will contact both snap rings when I drive it in.
I found a small handful of post referencing this, but not enough info. Do I drive the new thinner seal all the way to the front snap ring? Then install the rear snap ring even though it will be far from the end of the new seal?
I found a small handful of post referencing this, but not enough info. Do I drive the new thinner seal all the way to the front snap ring? Then install the rear snap ring even though it will be far from the end of the new seal?