Hydralic prime?

Charner MS · Feb 28, 2015

Helped a friend pull a Ford 2000 1962 apart and installed a new ring gear. After reassemble, no hydraulics. Attempted to prime pump but to no avail. Any suggestions.

ZANE · Feb 28, 2015

Remove the pipe plug at the front head of the pump. Start engine and run at low idle till no air bubbles come out with the oil.

Put a catch basin under the pump and you can pour the oil you catch back into the center reservoir when completed.

Zane

Ultradog MN · Feb 28, 2015

Did you replace the orings on both ends of the manifold?

souNdguy · Feb 28, 2015

Is there no flow or no 3pt. You can have flow but a stuck unloader and no 3pt.

Post back after pulling plug to seem if you have oil.

Also, keep in mind ice can plug suction line if the sump is wet...

Hydralic prime?

Charner MS

Member

ZANE

Well-known Member

Ultradog MN

Well-known Member

souNdguy

Well-known Member

Similar threads