2n engine mystery part

AZ ANTICS · Oct 21, 2014

I have my 2n down for an engine rebuild. Now that I am reassembling it I find a part I don't remember seeing when it was coming apart. The part is worn and broken and needs to be replaced. It looks like a washer about 1 1/2 inch in diameter , 1/8 inch thick with a notch out of it at the top and a flat spot below that about 1 inch across making the center hole not round, and another flat spot at the bottom about 1/2 inch across.the sides of the washer are about 1/4 inch across. Does anyone know where it goes and where I can get a new one? This one is broken and worn.
Mystery part

Royse · Oct 21, 2014

If it was in the bell housing, it sounds like the washer off the
end of a starter drive gear that broke and was left in there.
If that's the case they already replaced it.

AZ ANTICS · Oct 21, 2014

Thanks. I'll check the starter drive tomorrow .

Royse · Oct 21, 2014

I don't have a good picture of the washer, but if it is the one
I'm thinking of it would be the one to the right of the spring here.

souNdguy · Oct 22, 2014

chances are it's an old one. leftover in the bellhousing.

Ed Douglas · Oct 22, 2014

Yeah really........I found two in my 861...LOL...I gotta 20 dollar bill in my pocket you guys got this one called perfect

2n engine mystery part

AZ ANTICS

New User

Royse

Well-known Member

AZ ANTICS

New User

Royse

Well-known Member

souNdguy

Well-known Member

Ed Douglas

Member

Similar threads