After I went through the Howse rough mower, I went to Tractor Supply and bought an over-run clutch (~$78.00). The previous owner stated that the PTO shaft had been replaced at some point to 1-3/8. I pulled the PTO stub cap off to install it and found a 1-1/8 - 1-3/8 adapter. *sigh*
In the tradition of Arlo Guthrie - rather than pull that one off, I put mine on. Against every shred of common sense, I pinned my new over-run clutch to the adapter. Sloppy? Indeed.
Here's the real question: where can I get a good, quality PTO Master safety shield?
In the tradition of Arlo Guthrie - rather than pull that one off, I put mine on. Against every shred of common sense, I pinned my new over-run clutch to the adapter. Sloppy? Indeed.
Here's the real question: where can I get a good, quality PTO Master safety shield?