(800) 853-2651
SHOP NOW

9N/sherman question

I believe they were not made for the 9n but were made for the 2n and up. The 9n had a straight (9n7113) gear, in order to use the sherman in a 9n you would have to change out the gear to a (2n7113) helical gear

Kirk
 
reason I asked my brother claimed yesterday that our 9N had a Sherman. this was a 9N that had the four spoke steering wheel, lift out battery cover, starter button on dash and glow light. I rode that machine hundreds of time and never noticed a Sherman.
 
One of my early '41s had a sherman also but the gear was changed out. It only goes to reason that if they were building them at the same time as the early 9n's they would have made them in straight cut gear but in all the shermans I have pulled over the years in 9n's I have never seen one with the straight cut gear.

Kirk
 
good enough for me. I will have to question my brother some more next time I see him.

thanks.
 
like most retrofits. probably not a big job back in 1940 ( labor $ cheap ) to change out the gear and add the sherman at the same time... for an upgrade to an existing machine..e tc.
 
You must log in or register to reply here.

Similar threads

W
Sherman combo
Replies
8
Views
522
Pete76NYPa
P
B
8n /9n block swap
Replies
8
Views
505
Bruce(OR)
B
F
9n no spark
Replies
5
Views
396
Jim L WA
J
9
9n sherman step up to sherman combo
Replies
7
Views
656
Bruce(OR)
B
C
9N Grader?
Replies
9
Views
575
Mad Farmer
M
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top